Pakistan Monthly Review
AN INDEPENDENT SOCIALIST BLOG
Nothing human is alien to me – Karl Marx
Volume 1, No. 4, April 2019
Editor: Rashed Rahman
In our article How Urban is Pakistan published in 1999, we analysed the preliminary results of the 1998 census, particularly regarding urban population. We noted that city populations were higher than what official data was prepared to reflect, pointing to the issue of definition, specially the change introduced in the 1981 census and the use of administrative boundaries that contributed to the ‘underestimation’ of the urban population in the census. In a later version published as Underestimating Urbanisation, after the final results of the census had been released, we noted that leading Pakistani demographers and social scientists had commented and raised questions on the apparently low urban population reported in the 1998 census, considering it inconsistent with trends and evidence-based research. They argued that the urban population as a percentage of total population could not be less than 40 percent and could be up to 50 percent.
Why is it important to look at the urbanisation process? In transitional societies, urbanisation and its key characteristics are major determinants of the political process. Urbanisation has an impact on the realisation of political rights and participation in political processes, on the relationship of and responsibilities between the citizen and the state and the related institutional structures, on the nature of the breakdown of existing societal structures and the forging of new and complex ones, and on the composition of the revenue base and the criteria for resource allocations. There is a critical need to recognise and understand the urbanisation process. Here, we look at the process to present estimates of urbanisation and rural population.
In preparing estimates of urbanisation and rurality, we draw from our earlier work and use the census pertaining to 1998. However, before we proceed with the estimates, we need to discuss the matter of definition. This is important because the use of varying definitions may not capture the degree of population agglomeration, and changes in definition complicate comparisons over time. Similarly, global population and urbanisation databases, such as that maintained by the UN since 1950 (and other agencies) are derived from national data based on country-specific definitions used by various countries, making international comparisons more difficult. This should not be interpreted to mean that the national definitions are flawed, but that they distort cross-country comparisons and, in many places, the implied urban/rural dichotomy is inadequate to reflect the degree of agglomeration.
What then is urban and what is rural? Census offices usually define what is ‘urban’ or metropolitan for census purposes and assume the ‘residual’ to be rural. Governments use different definitions for policy – such as ‘urban and ‘rural’ in Sindh for job quotas to bring equity in government employment. On the one hand, ‘rural’ and ‘urban’ seem clear terms with contrasting images: isolated farms, tiny hamlets, cultivated fields and villages, versus the thriving city, skyscrapers and slums. This may have been a simple but adequate way of defining ‘urban’ and ‘rural’ some centuries or even decades ago, and while this dichotomy may be comfortable, it is imprecise and oversimplified. Life changes in a variety of dimensions along this route: from fields and intensive cultivation, villages and small market towns, to larger towns, small cities and the cosmopolitan city is not a single homogenous activity – it is multi-functional and diverse. Categorisations are largely becoming irrelevant as people live their lives in different ways rendering conventional definitions obsolete and many social, cultural, economic and environmental issues are inadequately addressed by current approaches separating ‘rural’ and ‘urban’ agendas.
The key features of the urban context have been defined as proximity, density, diversity, dynamics and complexity. Population density, an urban core and proximity to a city can be considered the key indicators that define the conceptual framework of agglomeration economies and rent. These critical factors have been used to create an agglomeration index as an alternative measure to adequately capture human settlement concentration rather than rely on ad-hoc and non-comparable definitions that, because of their implied urban/rural dichotomy, may not adequately reflect the degree of urbanisation.
(a) Population density
Population density is an important criterion for economic behaviour. To have a thick market, there must be a certain mass of people. Density is a proxy for market thickness. Dense proximity of a diverse pool of skills provides agglomeration benefits. It drives agglomeration economies that are a defining feature of cities – transport, infrastructure, amenities – that also bear on these economies. Density also affects unit cost of investment – fixed facility costs or higher mean travel cost to facility. Low-density areas may be too small to support competition in product and service markets, leading to capture by local monopolies.
(b) Urban Core and Proximity – distance to city
The existence of an urban core and its proximity (or distance) captures important determinants of economic opportunities and constraints – a proxy for market access and lower transport costs. Areas with ease of access or within commuting radius of a city may not be considered rural even if they are agricultural farms, and towns outside the radius may be considered rural. Economic activities change systematically with distance to a city: proximity and remoteness. Lack of an urban core and low overall population density impacts the ability to diversify the economic base compared to cities. The most extensively researched source of evidence for the claim that proximity is good for productivity is from studies of areas of dense economic activity: doubling of size increases productivity from 3-8 percent – from a town of 50,000 to one of five million means a 50 percent productivity increase. Further, this effect is larger in higher technology sectors.
What does Pakistan look like in terms of the critical factors that determine the urban and rural?
• Population density, and
• Urban core and proximity.
Overall population density in Pakistan has increased from 42.4 persons/sq km in 1951 to an estimated 231.6 persons/sq km in 2013 with the highest density in Punjab (488 persons/sq km, 2013 estimate) and the lowest in Balochistan (27.4 persons/sq km, 2013 estimate). The largest increase is in Balochistan (3-27 persons/sq km). There are also significant increases in Khyber Pakhtunkwa (KP) (61-313 persons/sq km) and Sindh (43-313 persons/sq km). Balochistan, Pakistan’s largest province in terms of area (43.6 percent), stands in sharp contrast to the other provinces. Seventy percent of Balochistan’s population lives at densities below 50 persons/sq km compared to one percent in Punjab and three percent in Sindh and KP. There is no population living at densities above 500 persons/sq km compared to 51 percent in Punjab, 41 percent in Sindh and 38 percent in KP. Other than Balochistan, the majority of the population lives within one hour from a city (83 percent, 80 percent and 68 percent in Punjab, Sindh and KP respectively) and a small proportion more than two hours away (the respective figures being one percent, seven percent, and nine percent). Balochistan presents a different picture with only 20 percent of the population living less than one hour and 20 percent living more than six hours away from a city.
In the framework of the critical factors and using criteria and thresholds that we establish, we can proceed to estimate the urban and rural in Pakistan. As mentioned earlier, the census defines only the urban and assumes the rest to be rural; we however establish criteria for both the rural and the urban. The base case criteria were adopted after considering and preparing estimates on several criteria. In the base case criteria, we consider (a) all areas with scattered populations (i.e. low population density), all areas that do not contain a town (i.e. urban core), and all other areas beyond a given travel time (i.e. proximity to city) to be rural. The base case criteria are: 250 persons/sq km; absence of a town of 50,000 within the area, and a travel distance of more than 75 minutes to a city; (b) a city core (100,000 or more in a single Pakistan census urban place) and its linked built-up and surrounding areas as ‘urban’ area provided they have a minimum density of 500 persons/sq km (overall). Of course, this leaves a gap between what we are considering rural areas and urban areas. As mentioned earlier, the categorisation of rural and urban appears inadequate and imprecise and there does not appear to be a natural dividing line or break point between the two. The urban/rural divide appears as a gradient, rather than a dichotomy. Behaviour and conditions change drastically along the gradient, and there seems no compelling reason to segment them into just these two categories. We therefore introduce the concept of an ‘urbanising’ area to classify areas that clearly are not rural since they have both an urban core and an overall density higher than the criteria we are using to classify the rural although they have not achieved our criteria for urban areas but could be considered in transition. We categorise all areas that have (i) a population density more than 250 persons/sq km (overall) and 400 persons/sq km in the urban core, (ii) a town (i.e. urban core) of 50,000 or more, and (iii) lie within a 75 minute distance of a city (100,000 or more) as ‘urbanising’ areas.
In looking at the comparisons, it should be borne in mind that while the census has only two categories – that defined as ‘urban’, with all the ‘residual’ non-urban areas treated as rural – we classify all areas in one of our three categories using defined criteria for each. Our ‘urban area’ estimates in the case of Punjab and KP are higher than the census urban population by 27 percent and three percent respectively. Our higher estimates are partly due to the use of administrative boundaries of the city by the census resulting in the exclusion of suburban development that forms an integral part of the city, which is excluded from consideration in the census but gets included in our estimates. On the other hand, our estimates for the urban area in Sindh are lower by 18 percent compared to the census due to the exclusion of small rural towns from our estimates for their lack of urban core (i.e. below our threshold size: town of 50,000 population) and lower density, but are included in the census due to their administrative status, while in Balochistan we do not find any area which meets our criteria for urban (primarily due to the density criterion). The main differences are in the case of our rural estimates: since (i) our ‘rural area’ estimates are derived from defined criteria for the ‘rural’ while the census assumes all the population outside the city boundaries to be ‘rural’; and (ii) we introduce the concept of an ‘urbanising area’ for the areas that clearly are not rural (they have both an urban core and an overall density higher than the criteria we are using to classify the rural) while they have not achieved the base case criteria for ‘urban area’. The introduction of ‘urbanising area’ brings into play the various elements of our criteria. In Punjab and KP, due to higher densities, presence of urban core (town of 50,000 population) and proximity to city (within 75 minutes of a city of 100,000), a very significant population classified as rural by the census falls in our urbanising area (the census classifies all areas outside city boundary as rural – the ‘residual’ approach). In Sindh, certain areas classified as urban by the census do not meet our criteria for an urban area but qualify as urbanising areas. In Balochistan, the Quetta area, containing the only city of the province, is considered as an urbanising area due to lower overall population density. There is a significant part of the population living in areas that are no longer rural but at different stages of urbanisation.
To sum up in the Pakistan context: the urban-rural definition of the census measures attributes of administrative areas and does not adequately reflect the process of urbanisation and agglomeration. We use density, urban core and distance to city to measure the urbanisation process and show that the census definition ‘underestimates’ the magnitude of the population in areas undergoing urbanisation (‘urbanising areas’). The definition, and the consequent flawed understanding of the urbanisation process, has led to serious policy distortions. It is both the nature and the magnitude of the urbanisation process that is significant, with important implications for the understanding of politics, poverty, empowerment, gender, governance, culture, inequality, informality and marginality. Based on an understanding of this process, many concepts have to change and policy interventions repositioned.
As the 1961 census noted, “The distinction between an Urban and Rural population is based on the definition of what is an urban population” and “The essential difference between a rural and urban population was that the former was mainly engaged in agriculture and the latter in commerce, manufactures and other occupations. Thus a place having a population of 5,000 or more would be considered a village if it did not possess urban characteristics” (Census 1931). Since census taking began in British India in 1861, “urban population meant the de facto population of cities and towns”. Cities and towns included: “(1) every municipality; (2) all Civil Lines not included in municipal limits; (3) every Cantonment; (4) every other continuous collection of houses inhabited by not less than 5,000 persons, which the Provincial Superintendent may decide to treat as town for census purposes.” The 1981 census changed this definition of ‘urban’ to an administrative criterion – that of the administrative status of municipal governance. Thus only the population living within the boundaries of municipalities and cantonments was designated as ‘urban’.
The definition adopted in the 1981 census, and subsequently for the 1998 census, was based on an administrative criterion. This implied that places that would earlier have qualified as urban, would be ignored. In the 1951 census, of a total of 235 urban places, 121 or 51.5 percent did not have administrative status; in the 1961 census, of 336 urban places, 219 or 65.2 percent did not have administrative status – and according to the 1981 definition would not have been classified urban. By using administrative status as the criterion for the 1981 census, 72 urban places in the 1972 census with a population of 1.356 million were declared ruralin 1981, thus shifting 5.7 per cent of the urban population to the rural; similarly 1,462 places with a population of 5,000 or more were classified as rural, some of which would have been classified as ‘urban’ had the definition not been changed. In the 1998 census, 3,691 places of 5,000 and above, with a population of 31 million, were classified as rural; once again, many of these would have been classified as ‘urban’ had the changed definition not been applied. An estimate shows that 361 places with a population of 5,000 or more that were considered rural in the 1998 census actually had urban characteristics better than many places considered urban in the census. If their population is considered urban, this would add another 6.5 percent to the 1998 urban population of Pakistan.
Leading from the use of an administration criterion is the use of administrative boundaries under the changed definition introduced in the 1981 census. This meant that people living outside the administrative boundaries were not counted as urban. City populations have extended outside these administrative boundaries through suburban and peri-urban development, a phenomenon that has gained in significance. For instance, in Lahore, public sector suburban development (Johar Town, Sabsazar, others) most private sector suburbs, and the Defence Housing Authority area, are not included in the count for urban Lahore. Similarly, settlements peripheral to the city, capitalising upon their proximity, transport links, employment opportunities and access to services have grown substantially and even acquired ‘urban characteristics’. Not surprisingly, the census results show that municipality population grew at 3.14 percent p.a. while the surrounding ‘rural’ areas at 4.14 percent p.a. Re-estimating the urban agglomeration would result in an increase of well over 20 percent to the 1998 census urban population of Lahore.
Reza Ali is Principal R. Ali Development Consultant, a research consultancy founded in 1972, working in areas of governance, public financial management and development. He is honorary director of the Urbanization Research Program, a not-for-profit research initiative to develop an improved understanding of the urbanisation process, its dynamics and impact.
This is an excerpt from a longer paper. The complete work is available at:
Crisis of Pakistan’s state and society
Dr. Saulat Nagi
The shape of things, extant and to come
Abdul Khalique Junejo
Mir Mohammad Ali Talpur
© 2018 Pakistan Monthly Review. All Rights Reserved.